Pi Zero W with OLED Type 3, possible?

[K2Kevin]

I have a few Pi Zero W used for another purpose previously (Pi-Star Ham Radio Hotspots). They have an attached OLED Type 3 display. Will this work on that display panel? If I have omitted any information, I would be happy to provide.

[kgutwin]

It's likely to work, given that those OLED displays seem fairly standardized. The main question will be whether or not the I2C address is the same as the default (3c) or if it's connected to a working I2C port on the Pi.

Try following the first few setup steps from the README and let us know what you find!

[K2Kevin]

I did find that it is at 3C I2C.

Update: I did actually go through your instructions previously to confirm, but did it once again now just to be sure. I think I may have another issue, since plugs seem to crash Octoprint during install. Just changed Locale to see if that helps.

 0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f

00: -- -- -- -- -- -- -- -- -- -- -- -- --
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
30: -- -- -- -- -- -- -- -- -- -- -- -- 3c -- -- --
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
70: -- -- -- -- -- -- -- --

[K2Kevin]

Found a support post about crashing plugins, and a fix. Changing the locale setting in config. Did that and IT WORKS! Thanks for your response!

[K2Kevin]

I do find when flipping display 180, the Virtual Panel (Micro Panel Tab) displays this upside-down. LOL So it does in fact mirror the display. Obviously not what I expected :)
180 flip more or less makes that Virtual Panel option useless or at least interesting.