Tecnoware ERA PLUS STRIP 800 new device support

[gpongelli]

Hi,
here's the setup to have Tecnoware ERA PLUS STRIP 800 working.
I've connected it via USB to a raspberry pi4.

/etc/nut/ups.conf  

[strip800]
  driver=nutdrv_qx
  desc="Tecnoware strip800"
  port=auto

$ upsc strip800@localhost
Init SSL without certificate database
battery.charge: 100
battery.voltage: 13.7
battery.voltage.high: 13.00
battery.voltage.low: 10.40
battery.voltage.nominal: 12.0
device.type: ups
driver.debug: 0
driver.flag.allow_killpower: 0
driver.name: nutdrv_qx
driver.parameter.pollfreq: 30
driver.parameter.pollinterval: 2
driver.parameter.port: auto
driver.parameter.synchronous: auto
driver.state: quiet
driver.version: 2.8.1
driver.version.data: Voltronic-QS 0.09
driver.version.internal: 0.36
driver.version.usb: libusb-1.0.28 (API: 0x100010a)
input.voltage: 240.2
input.voltage.fault: 240.2
output.current.nominal: 5.0
output.frequency: 49.8
output.frequency.nominal: 50
output.voltage: 236.5
output.voltage.nominal: 230
ups.beeper.status: enabled
ups.delay.shutdown: 30
ups.delay.start: 180
ups.firmware.aux: PM-V
ups.load: 12
ups.productid: 5161
ups.status: OL
ups.type: offline / line interactive
ups.vendorid: 0665

/etc/nut/upsd.conf  

LISTEN 0.0.0.0 3493
LISTEN 127.0.0.1 3493

/etc/nut/upsmon.conf 

MONITOR strip800@localhost 1 homeassistant <password> master

/etc/nut/upsd.users

[homeassistant]
  password=<password>
  upsmon master

thank you!