Led Issues?

[Udomaki]

Hello, so far I've soldered the pin header (socket for RP2040 pro micro and MCU slotted in). I've also soldered all the LED's, sockets, and diodes. I flashed the Ready-to-flash/qmk-RP2040/VIAL/klor_vial_right.uf2 and plugged everything in and my LED's aren't lighting up, am I doing something wrong? The build guide says the upside is that I should be able to test my LED's often, but none seem to be working. Thoughts?

[Udomaki]

I think I found at least some of my issue. I used the ready-to-flash files that are in the repo. Specifically I used the RP2040 files and it looks like it's crashing. When I plug it in to my mac I get the identify keyboard screen then it quickly disappears and then the RPI-RP2 drive pops up. I'll try building from scratch tomorrow and see if I can get things to run. Any help or thoughts would be appreciated.

[Lefuneste83]

Hi there, did you solve your issue ? I have not tested this keyboard on a Mac, you may have to adjust some settings in the FW config files. But it should not crash even with precompiled files.

[Chuong98CC]

hi, did you get the LED working? I used your ready_to_flash as well as built myself, but none of the led RGB working.
The weird thing is I accidentally flash the firmware from Sofle board then the RGB light on, but the keymap does not work exactly.

[Nornode]

Did anyone get anywhere with this?
I have been eyeing this keyboard for a while and I'd use it solely on a Mac... And LEDs are obviously a nice quality of life improvement.

[Chuong98CC]

yes, i got the RGB working, see my config:
https://github.com/Chuong98CC/zmk-config-klor/blob/master/config/klor.keymap